BNBFY - 220-06, ALKYD WALL PRIMER AND SEALER

  • MSDS: BNBFY
  • Manufacturer: O BRIEN CORP
  • Product Name: 220-06, ALKYD WALL PRIMER AND SEALER
  • National Stock Number: 8010-00N027780
Product Identification

Product ID:220-06, ALKYD WALL PRIMER AND SEALER
MSDS Date:03/20/1992
FSC:8010
NIIN:00N027780
MSDS Number: BNBFY

Responsible Party
O BRIEN CORP
450 EAST GRAND AVE
SOUTH SAN FRANCISCO, CA 94080
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 415-761-2300

Cage: 30806

Contractor
O BRIEN CORPORATION
SOUTH SAN FRANCISCO, CA 94080-6207 US

Cage: 72556

Ingredients

RESP TRACT & ACUTE NERVOUS SYS DEPRESS CHARACT BY

RTECS: 9999999ZZ


CAN

RTECS: 9999999ZZ


REPORT

RTECS: 9999999ZZ


LIVER & LUNG DMG. (CHRONIC) (STODDARD SOLV)

RTECS: 9999999ZZ


W/PERM BRAIN & NERVOUS SYS DMG. (CRYSTALLINE

RTECS: 9999999ZZ


REPORTS HAVE ASSOC PRLNGD & RPTD OCCUP

RTECS: 9999999ZZ


INTENTIONAL MISUSE BY DELIB CONC & INHAL CONTENTS

RTECS: 9999999ZZ


SHOWN TO CAUSE DMG TO KIDNEYS, LIVER, LUNGS, BLOOD

RTECS: 9999999ZZ


ORGAN (SPLEEN), AND PERIPHERAL NERVOUS SYSTEM.

RTECS: 9999999ZZ


RINSING. WHILE FLUSHING EYES, SEND FOR MED

RTECS: 9999999ZZ


FINISHES, VENT VAPS EMITTED ON HEATING.

RTECS: 9999999ZZ


CAREFULLY FOLLOW RESP MFR RECOMMENDATIONS FOR


CONFUSION, NAUS, VOMIT, ABDOMINAL PAIN, DIARR, LOSS

RTECS: 9999999ZZ


5.00.

CAS: 64742-88-7

Fraction By Weight: 15%

OSHA PEL 100 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)


KEROSENE (PETROLEUM), HYDROTREATED; (HYDROTREATED LIGHT

CAS: 64742-47-8

RTECS: OA5504000

Fraction By Weight: 10%

ACGIH TLV: 5 MG/M3 (MFR)


(ORAL,RAT) 15,300 MG/KG.

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: <1%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9293


SILICA, CRYSTALLINE - QUARTZ; (SILICA,

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: <5%

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293


RUTILE; (TITANIUM DIOXIDE)

CAS: 1317-80-2

RTECS: VM2940000

Fraction By Weight: 5%

OSHA PEL 10 MG/M3 (MFR)

ACGIH TLV: 10 MG/M3 (MFR)


1);

CAS: 1302-76-7

RTECS: BD1450000

Fraction By Weight: 30%

OSHA PEL 15 MG/M3 (MFR)

ACGIH TLV: 10 MG/M3 (MFR)


CAUSES IRRIT TO MOUTH, THROAT &

RTECS: 9999999ZZ

Hazards

LD50 LC50 Mixture:SEE INGREDIENT 3.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:(ACUTE) (MINERAL SPIRITS) INGEST:ASPIR
OF MATL INTO LUNGS DUE TO VOMIT CAN CAUSE CHEM PNEUM WHICH CAN BE
FATAL.A DECISION TO INDUCE VOMIT BASED ON MED ADVICE FROM PHYS/POIS
CNTRL CENTER PHYS. (STODDAR D SOLV)IF INGEST MAY CAUSE DIGESTIVE
TRACT IRRIT. ASPIR HAZ, DO NOT INDUCE VOMIT. INHAL MAY IRRIT
NOSE,(EFTS OF OVEREXP)
Explanation of Carcinogenicity:CRYSTALLINE SILICA: IARC GRP 2B, NTP GRP
2.
Effects of Overexposure:HLTH HAZ: THROAT & RESP TRACT, MAY CAUSE CNS
DEPRESS. IRRIT TO EYES. PRLNGD/RPTD CONT MAY CAUSE SKIN IRRIT.
(CRYSTALLINE SILICA, CRISTOBALITE) HUMAN SYS EFTS BY INHAL. MAY
CAUSE EYE IRRIT. (TITANIUM D IOXIDE) MATL IS CONSIDERED NUISANCE
DUST. SKIN CONTACT HAS SHOWN NO ADVERSE EFTS OTHER THAN DRYING &
(SUPP DATA)
Medical Cond Aggravated by Exposure:PREPLACEMENT & PERIODIC EXAMS
SHOULD BE GIVEN TO THOSE EXPOSED REG.

First Aid

First Aid:INGEST: DRINK 1-2 GLASSES OF H*2O TO DILUTE. KEEP PERSON
WARM, QUIET & GET MED ATTN IMMED. A DECISION TO INDUCE VOMIT MUST
BE BASED ON ADVICE OF PHYS/POIS CNTRL CENTER. NEVER GIVE ANYTHING
BY MOUTH TO AN UNCON PERSON. INHAL: REMOVE FROM AREA TO FRESH AIR.
RESTORE BRTHG. CONSULT PHYS. EYE: IMMED BEGIN FLUSHING EYES W/COOL
H*2O FOR AT LEAST 15 MIN, OCCASIONALLY LIFTING LIDS TO ENSURE THORO
(ING 18)

Fire Fighting

Flash Point:133F,56C
Lower Limits:1.00%
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP.
H*2O MAY BE USED TO COOL CLSD CNTNRS TO PVNT PRESS BUILD-UP & POSS
AUTO-IGNIT/EXPLO WHEN EXPOS (SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, SPARKS, FLAME & ELEC EQUIP. CLSD CNTNRS MAY EXPLO WHEN EXPOS
TO EXTREME HEAT. APPLIC TO HOT SURFS REQS (SUPP DATA)

Accidental Release

Spill Release Procedures:REMOVE SOURCES OF IGNITION. SOAK UP AND REMOVE
WITH INERT ABSORB MATERIAL WITH NON-SPARKING TOOLS. PROVIDE
ADEQUATE VENTILATION. USE APPROVED VAPOR RESPIRATOR.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS AND
USE AWAY FROM HIGH TEMPERATURE, SPARKS & FLAME. AVOID PROLONGED
CONTACT WITH SKIN.
Other Precautions:DO NOT INGEST. KEEP CONTAINER TIGHTLY SEALED WHEN NOT
IN USE. KEEP OUT OF REACH OF CHILDREN.

Exposure Controls

Respiratory Protection:USE A NIOSH/MSHA APPRVD PROPERLY FITTED MECH
RESP/MASK TO AVOID BRTHG VAP/SPRAY MIST DURING MIX, SPRAY,
APPLIC/CURING. USE TC 19C NIOSH/MSHA APPRVD PROPERLY FITTED POS AIR
SUPP RESP IN CONFINED AREAS/ WHEN OVERSPRAY IS PRESENT. (ING 20)
Ventilation:PROVIDE SUFF VENT IN VOL & PATTERN TO KEEP AIR CONTAM
CONCEN BELOW APPLIC OSHA PEL/ACGIH'S TLV LIMIT. FOR BAKING(ING 19)
Protective Gloves:SYNTHETIC RUBBER GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:PROTECTIVE OVERALLS RECOMMENDED.
Work Hygienic Practices:REMOVE AND WASH CONTAMINATED CLOTHING. DISCARD
CONTAMINATED SHOES.
Supplemental Safety and Health
FIRE FIGHT PROC: TO EXTREME HEAT. EXPLO HAZ: SPECIAL PREC. DURING EMER
CNDTNS, OVER-EXPOS TO DECOMP PRODS MAY CAUSE HLTH HAZ. OBTAIN MED
ATTN. EFTS OF OVEREXP: PARTICULATE ABRASION. EYE CONT MAY CAUSE
EYE IRRIT. EXCESSIVE EXPOS ABOVE TLV MAY CAUSE MILD PULM IRRIT.
(ALUMINUM SILICATE) IRRIT TO EYES & UPPER RESP (ING 7)

Chemical Properties

HCC:F4
Boiling Pt:B.P. Text:>300F,>149C
Vapor Pres:ING 1 & 3
Vapor Density:HVR/AIR
Spec Gravity:1.29
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:44.49

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, ACIDS, BASES.
Stability Condition to Avoid:HIGH TEMPERATURE.
Hazardous Decomposition Products:MAY PRODUCE FUMES WHEN HEATED TO
DECOMPOSITION. FUMES MAY CONTAIN CO, CO*2, AND NO*2.

Disposal

Waste Disposal Methods:DISPOSE IN SEALED METAL CONTAINER AWAY FROM HEAT
AND FLAME IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.
DO NOT INCINERATE CLOSED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.